The 061429 Osram Sylvania Hot Air tool provides a triple pass exchange housing.  The Serpentine VI heater's triple pass exchange housing uses incoming air to travel (AND COOL) down the outside shell of the Sylvania heater.  The air then travels through a slot and into air holes, where it rapidly warms as it flows over the heater element and exits out of the Sylvania heater. This hot air heater provides a maximum process heat of 1500 degrees F by providing two-stage 6,000 watts at 240 volt power and 20.8 max. amps.  This Sylvania heater is 10.88" long with a 1.25" outside diameter.

The housing for this heater is part number 057088.

Heater life can last up to 5000 hours if the manufacturer's guidelines are followed. Compressed air or air from a regenerative blower can be used to supply CLEAN and DRY air to your heater. Dirt, grease, oil, oil vapors, corrosive gases, and reactive gases will damage the air heater. Compressed air at typically 100 p.s.i. will need to be filtered to eliminate oil from the air supply. Air flow MUST be supplied to the Sylvania heater BEFORE the electrical power to the heater is turned on.  Keep maintaining air flow to the Sylvania heater until AFTER the electrical power to the heater is turned off.

CAUTION!!! Two stage heater elements utilize two different wire element diameters to achieve a hotter exit temperature by 50 to 100 degrees.  Due to this design feature, the heater can more easily burn out, if not set up with a carefully controlled closed loop process.

Osram Sylvania Air/Inert Gas heaters should ONLY be used to heat air or an inert gas. Using a Sylvania air heater with an EXPLOSIVE gas or in an EXPLOSIVE ambient can result in an EXPLOSIVE event, possibly leading to a SERIOUS accident or injury.

THIS IS LIST PRICING- CALL FOR SPECIAL DISCOUNTS OR QUANTITY DISCOUNTS THAT ARE AVAILABLE.